Cable Winding Machine Manufacturer Share: The Several Transformer Winding Methods

Transformer winding should pay attention to the insulation, size, and appearance of the steam, but also pay attention to the tightness of the winding, whether the coil is correct, whether the specifications are correct, the order, phase, and insulation level of the insulation material used, etc. After the coil winding needs to make a mark, one can understand a particular person winding and responsibility to the person. Transformer winding is very important. Transformer winding is not good. The transformer impacts the overall circuit and may lead to some signal interference and misjudgment. Transformer insulation also has a significant impact on the transformer.

Several standard transformer winding methods

Dense winding

Dense winding is the line and the line closely together, in the winding of the line may not be layered and cross and other phenomena, for example, dense winding a layer does not allow a second layer, does not allow the line and the line between the gap and cross and other phenomena.

1. The line is even and tight.

2. no knots, no crossover, no overlap. The upper layer does not fall into the next layer phenomenon.

Evenly winding

Even winding is the distance between the line and the line is roughly equal, winding the entire winding area, starting and closing the line to be close to the end control tape, but not allowed on the end control tape.

1. winding the wire around the entire winding area.

2. the distance between the line and the line is approximately equal.

3. the starting and closing lines are wound against the end control tape and have no upper-end control.

Parallel winding

More than two WIRE parallel winding the same group of lines, each parallel winding, do not cross, do not receive the line hanging the wrong foot position, in and out of the line to be at right angles.

This winding method can be roughly divided into four cases.

1. the same group and winding.

2. different groups and winding.

3. multiple groups and winding.

4. different groups or the same group of double and winding.

Same layer winding

1. the same winding layer is two or more winding groups wound on the same layer. Each winding line is independent of the insulation between the winding line.

2. winding to uniform, tightly lined up when winding the line can not climb the end control tape, in and out of the line at right angles, the specific requirements to meet the requirements of the operating instructions.

Centered winding

1. centered winding is in the skeleton winding area in the middle of the winding area.

2. the winding should be uniform, in and out of the line at right angles, explicitly following the work instructions to use the centered dense winding or centered even winding.

       TAIZHENG is a leading custom wire cable winding machine manufacturer & supplier in China, if you find any need about cable winding machine welcome to contact us