DONGGUAN TAIZHENG WIRE MACHINE CO.,LTD 
You are here: Home » News » Industry News » What should be paid attention to when the cable bunching machine is working

What should be paid attention to when the cable bunching machine is working

Views: 70     Author: Site Editor     Publish Time: 2022-01-17      Origin: Site

800mm double twist bunching machine


1. Wear labor protection equipment as required before the wire bunching machine operates.


2. Before running the cable forming machine, the operator should check the lubrication condition of all rotating parts of the machine; whether the installation of the replacement gear and the shifting of the gearbox handle are correct; whether the winch brake is flexible; whether the rear crank brake pin is placed correctly, Whether the cable tray is reliably locked on the tray; whether the adjustment of the traction wheel sub-ring is correct, and whether the protective device is correct.


3. When placing the bunching machine on the hoist coil, balance should be considered, and the hoist should be braked in advance to prevent the hoist from rolling up automatically.


4. After correct inspection of the cable bunching machine, the personnel in the rotating part should leave the safety fence to avoid accidents. First, run at low speed.


5. After the cable forming machine is running, check whether there is any abnormal sound in the operation part of the audio-visual machine. If there is any abnormality, it should be stopped in time.


6. When operating the rotating part of the cable forming machine during the production process, it is forbidden for the operator to wear gloves.


7. When the cable forming machine is running and producing, it is strictly forbidden for relevant personnel to enter and exit the guardrail.


8. Once the cable forming machine is put into use, it is forbidden to turn on the rotary switch on the console and the selection touch key on the interface.


9. When the cable handling machine stops due to a fault, the operator can restart the equipment only after the relevant faults are dealt with and all the emergency stop buttons are reset.


10. The "emergency stop" button is only used in emergency situations, and the stop button is not used under normal circumstances.


11. The limits of each electrical appliance on the cable forming machine must be complete, sensitive and reliable, and cannot be disassembled at will.


12. After the production of the cable forming machine is completed, be sure to cut off the power supply and do a good job of cleaning and sanitation of the equipment.


13. If there is a power failure, be sure to maintain the cable machine.


Taizheng produces extruders, stranding machines, take-up machines, cable equipment, rocking machines, bundle stranding machines, single stranding machines, cable forming machines, extruders, wrapping machines, etc. Welcome to buy.


Tell Me About Your Project
Any questions about your project can consult us, we will reply you within 12 hours, thank you!
CONTACT US
Leave a Message
CONTACT US
logo
MOBILE VERSION
CONTACT US
: +86-769-85723315
:+86-769-85723985
:  andrew@dgtaizheng.com
: No.16, Fuma Road, Chigang 
Industrial District, HumenTown, Dongguan, China.
Post Code:523905
MADE IN CHINA
DONGGUAN TAIZHENG WIRE MACHINE CO.,LTD     All rights reserved     IPXXXXXXXXX       Technical Support:MoLan Network